CSI-MOT-24 Stepper Motor Controller

DC 12V 24V Reversible Stepper Motor Speed Controller Stepping Motor Speed Governor Pulse Signal Controller LED Display

Reversible Stepper Motor Speed Regulator Stepping Motor Speed Controller Governor Pulse Signal Controller LED Display

Features:

Input: DC 7.5-24V
Output frequency: 40-200KHZ
Control range of stepping motor speed: 0~998 rpm

Interface:

+24V input
+5V output
PUL
DIR
EN
GND

Introduction:

CSI-MOT-24 is a versatile testing unit that we found useful during troubleshooting and building prototypes that involve motor control. Due to the lack of information online, we want to provide the Makers community basic steps on how to wire up the CSI-MOT-24 with different motor drive module.

Wiring:

CSI-MOT-24 connect QJ-215 Stepper Motor Driver

Connect VC+ and VC- on the CSI-MOT-24 to an 8V power supply.
Connect CP and DIR on the CSI-MOT-24 to the CP and DIR on the stepper motor driver QJ-215 accordingly.
Connect +5V on the CSI-MOT-24 to the +5V on the QJ-215 to power the driver.
Connect the VCC and GND on the QJ-215 to a 13V power supply.
Make sure to connect all ground wire accordingly. This is crucial for the system operational.

Conclusion:

CSI-MOT-24 is a versatile testing unit that we found useful during troubleshooting and building prototypes that involve motor control. This unit can also connect to DC motor driver and can be used as a servo motor testing. We will cover this in future projects.

Operation: