Learn How-To Soldering With Spinning Wheel Kit

The OSEPP Spinning Wheel Kit comes with everything you need to learn how-to solder. Soldering is a straightforward process, there are a couple of tricks and tips that we can give you to archive a good and clean solder joint. We hope that at the end of the article, you would be more confident about how to solder, and also a little toy to remind you how to do it right!

Table of Content
  • Part List
  • Inventory the OSEPP Kit
  • Solder The Components
  • Solder LEDs
  • Conclusion
OSEPP Spinning Wheel Kit
Part List
  1. OSEPP Spinning Wheel Kit
  2. Solder Station
  3. Solder
  4. Flux
Inventory the OSEPP Kit
Inventory All Components
Solder The Components

First, let’s warm up with soldering the tactile switch! It is very important that you use a sufficient amount of flux for maximum heat transfer.

Soldering Tactile Button

The secrets of a perfect resistors soldering job are flux, one side at a time, and the most important one, tape them down!

Soldering Resistors

Finally, solder the capacitor and buzzer. These two components are simple to solder, just make sure the polarity on the buzzer.

Soldering Buzzer and Capacitor
Solder LEDs

If you have to solder LEDs before you know it is not hard. However, to archive, a unified sitting flush to the PCB surface could be frustrating. Here are 3 tips for that!

Soldering 24 LEDs
Conclusion

The OSEPP Spinning Wheel Kit comes with everything you need to learn how-to soldering. We hope the couple of tricks and tips that we can give you to archive a good and clean solder joint. Now you can show all your friends how clean and professional your project looks.

Let’s Play

Leave a Reply