ARD-01B Arduino Basics Companion Kit

Arduino Basics

Kit comes with everything you need to build your own:

Arduino Starter Kit Includes:

1ea - 6 feet USB type A to mini-B
2ea - Tact push switch 6mm x 6mm – through hole
11a - DIP switch 4 position – through hole
1ea - 1Kohm potentiometer (variable resistor) – long pins
1ea - 10Kohm potentiometer (variable resistor) – long pins
20ea - 330 ohm axial resistor, 1/2W, 5%
5ea - 1 kohm axial resistor, 1/2W, 5%
5ea - 10kohm axial resistor, 1/2W, 5%
2ea - LED through hole – Red, 8.7mm height, ~2V drop, ~10-20mA
2ea - LED through hole – Yellow, 8.7mm height, ~2V drop, ~10-20mA
2ea - LED through hole – Green, 8.7mm height, ~2V drop, ~10-20mA
2ea - LED through hole – White, 8.7mm height, ~2V drop, ~10-20mA
2ea - LED through hole – Blue, 8.7mm height, ~2V drop, ~10-20mA
2ea - Two digits 7-segment LED – RED
1ea - Buzzer, 5Vo-p
2ea - NPN transistor
1ea - Breadboard – 30 columns x 14 rows (include 2 VCC and 2 GND)
10ea - 6 inch male-to-male jumper wires (red)
10ea - 6 inch male-to-male jumper wires (black)
10ea - 6 inch male-to-male jumper wires (white)
10ea - 6 inch male-to-male jumper wires (grey)
10ea - 6 inch male-to-male jumper wires (blue)
1ea - 4x AA battery enclosure with DC power jack and ON/OFF switch, cable length 4″
2ea - 2cm x 2cm x 3mm thick double side tape
1ea - Information sheet – Arduino UNO diagram + basic electronic theory
1ea - Kit container