Dual Loop PID Controller Module

2 loop PID control algorithms built in one package
3 analog input/1 analog output/1 digital input/1digital alarm output for 1 PID loop
Support multiple analog I/O ranges: 0 ~ 10 VDC, 0 ~ 20 mA and 4 ~ 20 mA
Support heating/cooling (direct/reverse) action mode
Support loop open/close (PID disable/enable) and analog output manual control modes
Built-in watchdog timer

Advantech’s ADAM-6022 is an Ethernet-enabled dual-loop PID controller for general purposed PID control applications. A user-friendly utility software is included for users to set PID parameters (Pv, Mv, & Sv). Through the integrated web page, users can monitor and change the control set point through the Internet via web browser. The ADAM-6022 also supports MODBUS/TCP protocol. HMI software can easily access this module to monitor the I/O data and change the control parameters.

Specifications

Display

LED Indicators: Status, Comm, Link, Speed

Power Supply

Power Requirement: 10~30 VDC

Analog Input

Channel Independent Configuration: Yes
Sampling Rates: 10 samples/second
Resolution: 16-bit
Channels: 6 differential
Voltage Range: ±10 V
Current Input: 0~20 mA 4~20 mA
Input Impedance: 20 MOhm
Span Drift: ±25 ppm/°C
Zero Drift: ±6 µV/°C

Analog Output

Channels: 2
Voltage Range: 0~10 V
Current Output: 0~20 mA 4~20 mA

General

Watchdog Timer: System (1.6 second) & Communication (programmable)
Temperature (Operating): -10~70 °C (14~158 °F)
Humidity: 20~95 %RH
Temperature (Storage): -20~80 °C (-4~176 °F)
Interface: 10/100Base-T(X)
Peer-to-Peer: No
GCL: No
Isolation Protection: 2000 VDC
Communication Protocol: Modbus/TCP, TCP/IP, UDP, and HTTP
Communication Speed: Ethernet 10/100Mbps
Comm. Distance: Ethernet 100 m
Connector: 1 x RJ-45 (LAN) & 2 x plug-in terminal block (I/O and power)

Digital Input

Input Voltage: Dry contact: Logic level 0: close to GND Logic level 1: open Wet contact: Logic level 0: 0~3 VDC Logic level 1: 10~30 VDC
Channels: 2

Digital Output

Channels: 2, open collector to 30V, 100 mA max. load
Power Dissipation: 300 mW for each module